PAT-TRAP, INC Recommends replacing Pat-Trap machine parts with OEM Pat-Trap parts.
NEVER STAND IN FRONT OF A TRAP MACHINE. THE TRAP MACHINE MUST BE TURNED OFF AND THE SPRING RELEASED BEFORE ENTERING THE TRAP HOUSE. NEVER ATTEMPT TO MAKE ANY ADJUSTMENT WHILE THE THROW ARM IS COCKED.
NEVER ATTEMPT TO LOAD THE TRAP WHEN IT IS COCKED. ALWAYS RELEASE THE TARGET FROM THE TRAP MACHINE. NEVER ADVANCE THE THROW ARM BY HAND WHEN THE ON/OFF/RELEASE SWITCH IS IN THE ON POSITION. THIS MAY DAMAGE THE MACHINE.
The target throw arm extends 4″ beyound the throw plate. Keep away from moving parts. Never stand in front of the trap machine.
USE 5W20 MOTOR OIL FOR YOUR HYDAULIC OIL CHANGE. (YOU CAN USE EITHER SYNTHETIC OR REGULAR OIL ANY BRAND IS FINE.)
SINGLE/DOUBLES ANGLES and WOBBLE ANGLES
Singles & Doubles Angle: It is recommended that you mark the elevation cog at 20° for singles and 23° for doubles, at 45-51 yards at 9 feet elevation, using a protractor.
Wobbles Angles: Left/Right Angle = 8” => 50° , Left/Right Angle = 10” = 60°, Down Angle = 7° Min, Up Angle = 25 ½° Max.
Pat-Trap-Serial-Number-Identification
Recommend-Tools-to-have-on-hand
#2/3 Switch PreSolidState Wiring Guide
Trap-Wobble-Power-Control-Box Wiring Diagram
Combination_skeet_and_trap_field_layout
G-Series-Directions-with-the-Elevated-Roller-Plate-System-to-elimiate-2-guide-spring
G-Series-Directions-to-Convert-from-Surface-Mounted-Roller-Plate-System
REPLACEMENT-OF-A-HYDRAULIC-VALVE-1
WOBBLE-WIRING-GUIDE-FOR-11A-12A-switches-for-machines-G2418-G6305
WIRING-GUIDE-FOR-FIELD-ANGLE-LIMIT-SWITCHES-11-12
WIRING-GUIDE-FOR-FIELD-ANGLE-LIMIT-SWITCHES-11-12-for-machines-G2418-G6305
REPLACEMENT-OF-A-HYDRAULIC-VALVE